PRODUCT
DESCRIPTION
AMSOIL Ea By-Pass Oil Filters (EaBP) provide the best possible
filtration protection against wear and oil degradation. Working
in conjunction with the engine’s full-flow oil filter,
AMSOIL Ea By-Pass Filters operate by filtering oil on a
“partial-flow” basis. They draw approximately 10
percent of the oil pump’s capacity at any one time and trap
the extremely small, wear-causing contaminants that full-flow
filters can’t remove. The AMSOIL Ea By-Pass Filter
typically filters all the oil in the system several times an
hour, so the engine continuously receives analytically clean
oil.
Higher Efficiency
AMSOIL EaBP Filters have an efficiency of 98.7 percent at two
microns. At normal operating RPMs the EaBP Filter will filter all
of the oil in a typical five quart sump in less than 10
minutes.
Superior
Construction
The superior construction of AMSOIL EaBP Filters provides better
sealing and increased longevity along with superior corrosion
resistance. AMSOIL EaBP Filters have a marine powder coated
exterior; and their zinc-dichromate base plates increase rust
protection. EaBP Filters have a nitrile HNBR gasket and an orange
silicone anti-drain valve. The two stage pleated and layered
cellulose/full synthetic media has an efficiency rating of 98.7
percent at two microns.
Longer
Lasting
When used in conjunction with AMSOIL motor oil and an AMSOIL EaO
or Donaldson Endurance™ filter, the EaBP Filter should be
changed every other full-flow filter change up to 60,000 miles.
When used with other brands of motor oil or full-flow filters,
the EaBP Filter should be changed every other full-flow filter
change. AMSOIL recommends using oil analysis when extending oil
drain intervals.
Increased Oil Capacity
The increased fluid system capacity and filtration life provides
improved oil cooling and ensures that equipment constantly runs
on clean oil. Engine efficiency is increased, providing extended
engine life.
Soot
Removal
AMSOIL has
designed a new high-efficiency by-pass filter element that is
also a soot removal device. AMSOIL Ea By-Pass Filters use a
synthetic/cellulose sandwiched media. The inner layer of the
element is composed of a highly efficient cellulose media covered
with a full synthetic media outer layer. According to ISO 23556
testing, these filters remove 39 percent of soot contaminants
less than one micron. Soot removal efficiency increases
approximately 10 to 14 percent when the EaBP Filter is used in
conjunction with a standard full-flow filter.
By-Pass Filtration
Benefits
• Dramatically Extended Drain
Intervals
• Improved Oil Cooling
• Increased Filtration Capacity and Life
• Increased Fluid System Capacity
• Efficient Small Particle and Soot Removal
• Significantly Extended Engine Life
• Equipment Constantly Runs on Clean Oil
• Increased Engine Efficiency
• Remove Particles Less Than One Micron
AMSOIL By-Pass Filter
Replacement Chart
AMSOIL By-Pass Filter
Replacement Chart |
Type of
Unit |
Stock
Number |
Size
(Approx.) |
Additional Oil
Needed |
Crankcase
Capacity |
Applications |
SINGLE SPIN-ON
ELEMENT
(Used with BMK21 or any DUAL REMOTE
SYSTEM)
|
EaBP90 |
Diam. = 4.3 in.
Height = 5.8 in.
With Mnt. = 8 in. |
1 qt. |
up to 9 qt. |
Pleasure Vehicles,
Light Trucks and Smaller Commercial Applications |
EaBP100 |
Diam. = 4.3 in.
Height = 7.3 in.
With Mnt. = 10 in. |
1.5 qt. |
up to 15 qt. |
EaBP110 |
Diam. = 4.3 in.
Height = 10.4 in.
With Mnt. = 12 in. |
2 qt. |
up to 21 qt. |
DUAL SPIN-ON
ELEMENT
(Used with BMK22
DUAL-GUARD)
|
(2) EaBP90 |
Width = 5
in.
Length = 9.5 in.
Height = 8 in. |
2 qt. |
15 to 18 qt. |
Large Trucks,
Construction, Farm and Industrial Equipment
(minimum sump capacity = 15 qt.)
|
(2) EaBP100 |
Width = 5
in.
Length = 9.5 in.
Height = 10 in. |
3 qt. |
15 to 30 qt. |
(2) EaBP110 |
Width = 5
in.
Length = 9.5 in.
Height = 12 in. |
4 qt. |
15 to 42 qt. |
SPIN-ON ELEMENT
(Used with BMK30
Heavy-Duty By-Pass System)
|
(1) EaBP120 |
Width =
5.35 in.
Length = 12.12 in.
Height = 17.5 in. |
4 qt. |
15 to 42 qt. |
Large Trucks, Construction,
Farm and Industrial Equipment, (minimum sump capacity = 15 qt.),
the BMK30 kit can be mounted in series for sump capacities
greater than 42 quarts. |
Normal Service Life
b:When used
in conjunction with AMSOIL motor oil and an EaO or Donaldson
Endurance filter, EaBP Filters should be changed every other full
flow filter change up to 60,000 miles. When used with other
brands of motor oil or full flow filters, the EaBP filter should
be changed every other full flow filter change. AMSOIL recommends
using oil analysis when extending oil drain
intervals.
|
a. Filters can be used on sumps of larger
capacity but then require more frequent replacement. Full details
on service life included with filter installation
instructions.
b. Data determined in a non-turbo gasoline
engine with AMSOIL 100% Synthetic Motor Oil and AMSOIL Ea
Full-Flow Oil Filter. Service life varies in other engines (turbo
and diesel) and with other
oils and filters.
NOTES:
1. Special adapters and hardware may be required for some
installations.
2. Contact AMSOIL INC. Technical Services for instructions before
installing on vehicles with cast aluminum oil pans. Call
715-399-TECH (8324)
APPLICATIONS:
Vehicles with sump
capacities up to and including 15 qts |
Mount |
Filter |
BMK21 (Filters sold
separately) |
Any size AMSOIL Ea By-Pass
Filter Element |
BMK23 (Filters and spin-on
adapter sold separately) |
Any size AMSOIL Ea By-Pass
Filter Element, and 3/4"-16 thread EaO filter as room
permits |
BMK25 Cummins Diesels
(Filters and spin-on adapter included) |
EaO26 and EaBP100 Ea
By-Pass Filter Element |
BMK26 International
Diesels
(Filters and spin-on adapter included) |
EaO26 and EaBP100 Ea
By-Pass Filter Element |
BMK27 Duramax Diesels (in GM
Pick-ups)
(Filters and spin-on adapter included) |
EaO26 and EaBP100 Ea
By-Pass Filter Element |
Vehicles with
sump capacities greater than 15 qts |
Mount |
Filter |
BMK22 Dual Gard (Hose and
filters sold separately) |
Any size AMSOIL Ea
By-Pass
(mount requires 2 filters) |
BMK30 Dual Gard (Hose and filters
sold separately) |
EaBP120 Ea By-Pass Filter
Element |
|